These non stabilised chlorine granules are ideal for shock dosing or regular sanitisation of swimming pool water.

Application Instructions

1. Maintain pH levels within the ideal range 7.2 - 7.6 and free chlorine residuals between 1 - 3mg/l.  If the levels are not in this range, adjust.
2. Shock or oxidising procedures are recommended either weekly or fortnightly with a maximum of 10mg/l (ppm) for a full shock treatment.
3. If the water temperature is 20 C or higher and water depth at least 4ft deep, this product can be carefully broadcast directly over pool surface. Always check wind direction before broadcasting.  Alternatively, pre-dissolve this product in a clean plastic container at a maximum rate of 100g of product in 2.2 gallons (10 litres) of warm water.  Stir well to ensure product is fully dissolved.  Add the resulting solution to the pool whilst the pump(s) are turned 'on' preferably near the water inlets to aid distribution.
4. Repeat dose/application if necessary to achieve the desired level.
5. After using this product pool water may become temporarily cloudy, so keep the filtration pump running until it clears.
6. Allow the chlorine level to drop below 5 ppm before bathing recommences, and wait for at least 30 minutes before bathing starts.

General Precautions

Dosing

• Wear eye and face protection and ensure granules are not blown back into your face.
• Never mix with any other chemicals including cleaning products and chlorine products, as a dangerous reaction may occur.
• Do not pour this product into a pool skimmer basket containing chlorine tablets or any other product.
• When pre-dissolving product always add to water not vice versa.

Handling/Storage

• Handle products in a well-ventilated area, preferably outdoors.
• Wash hands after use.
• Ensure chemicals do not become damp in storage - store in a cool dry place.